Inside HP Omen 17 (2017) – disassembly, internal photos and upgrade options

Although there’s no service hatch to be found on the bottom of the chassis, the access to the internals is hassle-free.

You can find the available models here: http://amzn.to/2sHVE36

1. Removing the bottom piece

Remove all the screws around the chassis and you will be able to safely pry up the bottom. This will reveal all of the internals


2. Storage

The laptop offers the usual M.2 SSD slot plus a standard 2.5-inch HDD/SSD slot and potentially with another 2.5-inch bay if you swap the optical drive for a caddy. The unit we’ve tested came equipped with 256GB Samsung PM961 M.2 PCIe NVMe SSD (2280) and a 256GB Samsung PM961 M.2 PCIe NVMe SSD (2280) and a HGST 1TB HDD.


3. Memory, battery and Wi-Fi

The laptop comes with two RAM chip slots supporting up to 16GB DDR4-2400 each. Our unit was equipped with exactly 2x 16 DDR4-2400 making a total of 32GB of memory. The chips are manufactured by Samsung.


The Wi-Fi module is made by Intel with model number 7265NGW.

There’s a slight decrease in battery capacity compared to the previous generation – 86Wh.


4. Cooling system

The new Omen 17 comes with a solid cooling solution with two big heat pipes going across the GPU and a smaller one for the CPU. The two cooling fans are located on each side of the laptop pushing the hot air out the back.

The full review of the HP Omen 17 (2017) can be found here.

You can find the available models here: http://amzn.to/2sHVE36

S'abonner à
Notifier de
guest
5 Comments
Feedbacks de Inline
Voir tous les commentaires
Jan Janowski
Jan Janowski
6 années il y a un an

Is there any chance that you can show disassembly instructions for a HP Omen T17-W200 CTO model?
No access door… Want to upgrade the big 3 when I go out of warranty….. HD to SSD, Add another 8GB Ram, and add 512Gb M2 (HP Support tells me that M2 max’s out at 512Gb due to design of motherboard…. Thank You

Geoff Smith
6 années il y a un an

I have this laptop but it doesn’t have an optical drive, so hoping to put a 2.5 hard drive on the left, where would I get and what parts would I need to add one?

Damian
Damian
5 années il y a un an
Répondre à  Geoff Smith

Also doing the same, just need a 9.5mm ODD to HDD enclosure and the data connector

Dan
Dan
5 années il y a un an
Répondre à  Damian

where does one find a data connector, and what do you connect it to?

Thiago Cesar Palokowski
Thiago Cesar Palokowski
5 années il y a un an

Hello! My model came without the ODD Drive and cable, but I want to put another HDD on the ODD Interface, can you show me or tell me the ODD Cable part number or a compatible model? (I Found a lot of ENVY ODD cables on the market, for example), Thanks!!!