Inside Acer Predator 17 (G9-793) – disassembly, internal photos and upgrade options

We just took apart the refreshed Acer Predator 17 with GTX 1070 to find out that absolutely nothing has been changed from its predecessor. The same cooling design, the usual upgrade options and it’s just as easy to maintain.

You can find here the current Acer Predator 17 generation here as well as the new one when it comes out: http://amzn.to/2cLQW10

1. Service cover

The maintenance hatch is present again in this version of the Predator 17 and gives access to the most commonly upgraded parts – RAM and storage. But since the laptop supports up to 64GB of DDR4-2400 RAM, which means four 16GB RAM sticks are needed to reach this amount. But only two of the slots are located under the service lid while the other two can be found on the other side of the motherboard after a full disassembly, which takes some time but isn’t as big a hassle.

img_20161003_132604
img_20161003_132723

The 2.5-inch HDD is made by HGST and delivers 1TB of storage capacity.

img_20161003_132735

Interestingly, the notebook we received from Acer features a Toshiba-made M.2 PCIe NVMe SSD with 256GB capacity. Read speeds are slightly below the usual OEM Samsung drives but scores higher when it comes to write speeds. It has a model number of THNSN5256GPU7. Unfortunately, Acer sticks with the 2280 + 22110 SSD configurations so you might find it hard to come across a compatible 22110 stick.

img_20161003_132753
img_20161003_132806
img_20161003_133603

And here are the RAM chip slots, which are empty. Our unit came with 16GB of DDR4-2400 RAM provided by only one SK Hynix chip.

img_20161003_133612

2. Removing the bottom cover

In order to do this, you will have to make sure you’ve removed all the screws around the chassis. There are a few hiding under the service lid and two located under the optical drive.

img_20161003_135225

Speaking of which, it can be swapped with an extra cooling fan just by pressing the lever switch. When released, it will pop out a little and then just pull it outside of the chassis.

img_20161003_134012

3. Battery and Wi-Fi card

The battery is located on the bottom left corner – as it was before – and, of course, it’s rated at 88.8Wh.

img_20161003_135318

The Wi-Fi card is placed right next to one of the cooling fans and it’s manufactured by Hon Hai/Foxconn.

img_20161003_135517

4. Cooling system

As we already said, the cooling design hasn’t been changed at all. Two main heat sinks take care of the CPU and GPU with the usual copper heat pipes connecting the fans and the heat sinks. Also notice the metal blades, which are believed to be thinner and thus more effective than the conventional propellers. We have no reason to think that the cooling system won’t be able to support the considerably more powerful GTX 1070 than the GTX 980M from last year’s Predator 17.

img_20161003_135541
img_20161003_135536

You can find here the current Acer Predator 17 generation here as well as the new one when it comes out: http://amzn.to/2cLQW10

サブスクライブ
通知する
guest
15 Comments
インライン フィードバック
View all comments
Ana Carvalho
7 歳月 前

Hi, I just bought one of this, although I read that it might come with 2 X128 M.2 PCIe NVMe SSD instead of the great toshiba; but I can upgrade it later when it becomes cheaper for a 512. I am interested in adding 16 GB of memory, can you advise where do I get information on that? What kind of memory is compatible?
Thanks

Sunny jasti
Sunny jasti
7 歳月 前

I have acer predator 17 I tried resetting the battery by pinning it in the small tiny hole and my laptop battery stops charging and I cannot use it without plugging it in to the power supply can you help me ?

james
james
7 歳月 前

does it have any spare m.2 slots?

Joe
Joe
7 歳月 前
返信  james

It has two M.2 slots. One stacked on to of the other. You can see them in the fourth photo.

Lyle
Lyle
7 歳月 前

I have the g5-793-72au model with no DVD rom drive. My question is does this model still have the sata slot to hook up a DVD drive or another SSD or HDD?

jfield9734
jfield9734
5 歳月 前
返信  Lyle

Yes it does. You will have to figure out how to mount the drive though since there is no bracketry there. And you will have to remove the entire bottom cover if you ever want to access it.

mike
mike
7 歳月 前

how to remove service cover. I see 2 screws, but the cover does not just come out. seems like something is holding it. where the screws are, the panel does lift a bit but again, it seems like something is holding it down a bit.

mikec
mikec
6 歳月 前

Can the back cover of the acer predator be replace?!

thorromania
6 歳月 前

Hey…awesome review….question: I am interested in buying one and want to change the 1080p display for a 4k one …what kind of jack is the 1080p one having? do you see that as a problem, if I buy one?

Sean T
Sean T
6 歳月 前

Okay so I have the G9-793-78CM (2016) Model that shipped with a 256GB M.2 Array (Raid-0). The individual M.2’s are LITE-ON Brand and they are BOTH 2280 in size but the top one has a little metal adapter clip that makes it 30mm longer to fit in the 110mm slot! So if you wanted to you could shove two 960 Evo’s in there however you dont benefit any speed by RAID-0-ing them together because they would already max out the PCIe lane speed. TMYK

Thoringer
Thoringer
6 歳月 前

I am still looking fore a way to put in a second SATA drive. The CON5100 is used for one SATA cable and there is no second connector of that kind on the board, but there is a second bay in the middle to physically house one. Does anyone know if that non-populated CON4400 somehow can be used for that? (it is right next to the drive bay).

Sam
Sam
6 歳月 前

Hello, I have a g5-793 without a DVD drive. Instead of the drive there is just a plastic piece to cover up the hole. Are there still two screws under that plastic? I can’t find a way to remove it…

gawlik
gawlik
4 歳月 前

Can i put on g5-793 back case from g9 and add suboffer and dvd ? i can buy this parts 😉

Afy
Afy
3 歳月 前

Hello i have a problem with my Spring Switch. Since this is a second hand unit, the switch somehow was modified and it is usefull but after 6months, the spring switch (which has been tape together by the previous owner) fall off. Is there anyway i can modify the switch? I have plenty of pictures to show u, gladly if I can share it with you via email. Thank You.